Your site plan
Your garden file

Your site plan

A scaled drawing of one area at a time: the boundaries, the gates and doors, the trees, spigots, downspouts, meters and marked utility lines, and your beds, patios and plants drawn at the size they will actually be. Try arrangements as options and print the one you choose at scale.

On a first pass this plan is optional. Graph paper and a pencil do the same job and are faster to think with; what the tool adds is a scale it cannot lose, plant sizes read straight off the plant list so no number gets mistyped, a warning when a plant at mature size would narrow a path, and a print at true scale with a bar you can check against a ruler. Draw the area you are changing first: the boundaries, then the gates and doors, then the fixed things you cannot move. A reader who works on paper loses the path check and the automatic plant sizes, and loses nothing else.

How to use the plan

  • Measure first, in this order: the boundaries of the area, run by run; the house wall and every door and gate, with its width and where it sits along the wall; the hard surfaces; then everything else by two measurements from two fixed points, which is the triangulation method in Measuring and drawing your site. The drawing is only as good as the boundary runs, so check one side by comparing the sum of its parts against a single long measurement before you start.
  • Put the fixed features on before the plants. Tree canopies, existing shrubs, the spigot, each downspout, the meter, the A/C unit, any septic lid or cleanout, and the marked utility line with its no-dig zone. Those decide where planting can go, and the no-dig zone in particular has ended more plans than any design preference.
  • Draw plants at mature spread. They arrive from the plant list at the mature width you recorded in feet, which the sheet converts to inches for the drawing. A plant that arrives at its pot size is a plant whose mature width you have not filled in.
  • Draw, then check three things. That no two plant circles overlap; that anything you marked as a walking path is still at its width once the plants are at mature size, which the plan flags for you; and that nothing at mature spread crosses a boundary or presses against a wall. The wall figure is NC State Extension's: half the mature width plus at least a foot.
  • Make options rather than edits. Copy an option before you rearrange it, so you can put the two side by side instead of trying to remember what you changed.
  • Print at scale and check the bar with a ruler before you take the sheet outside and start measuring off it.
Fictional example

The example is Rosalind's driveway strip (fictional): 12 feet by 4, with the downspout marked, and three wild bergamot drawn at a 3-foot mature spread. Loading it shows the arithmetic the manual rests on in one picture: three plants at mature size fill most of a 12-foot strip, which is a long way from what a trolley at a nursery suggests. If you have given dimensions in setup, an area of your own size is started for you as well, with the wall lengths ready to be corrected to what you actually measured.

Limits

This is a drawing, not a survey and not an engineering document. It shows where you told it things are. It cannot tell you where your property line legally falls, which only a licensed land surveyor establishes; whether it is safe to dig, which only the 811 locate marks answer; whether the ground is level, since a plan is a view from above and foreshortens a slope; or whether anything you have drawn is permitted, which is your local building or planning office and, where one applies, your HOA. The path warning compares a measurement with the path width set on this page, which is 54 inches by default after NC State Extension's front-walk minimum; it is a prompt, not an accessibility assessment.